by fheflin
You will find this cool car at the end of "The Things You Can Think" book by Dr. Seuss.
Print Settings
Printer brand:
Prusa
Printer:
i3 MK3
Rafts:
Yes
Supports:
Yes
Resolution:
0.3 mm layer for the body, .15 for the steering wheel and FrontPieceB, 0.2 mm or the other parts
Infill:
20%
Filament brand:
Matterhacker and Prusament
Filament color:
Blue and Yellow
Filament material:
PLA, PETG, ABS, whatever you haver
Notes:
This is an easy and fast make. Print the main body horizontally with supports on the BUILD PLATFORM ONLY. The only other piece that is good to support is FrontPiece3 and BackPiece. To secure the legs in each side I used a 3/16 inch(4mm) screw and nut. For the purists,I am working on a threaded part to print for this screw which I will upload eventually, but some printers can't handle threads that small.
important notes: You will need to bend the steering wheel shaft to fit. Dip it in hot water or use a heat gun then bend an angle as shown in the photo. You can do the same to the stem of the back piece if you want to get the look you like.