Bugz are fun little things that are probably the smallest biting 3D print available... the mouth is springy, opens and closes... and they have teeth. Printed with PLA and at least 25% infill should result in a surprisingly strong bite for such a small creature.
At standard scale Bugz are only 25mm in length, 8mm wide and 11mm tall. This makes them a very small print that takes next to no time and uses less than 2gm of filament including a Raft. Perfect for using off a small amount of filament at the end of a spool.
Printer Brand:
MakerBot
Printer:
MakerBot Replicator (5th Generation)
Rafts:
No
Supports:
No
Resolution:
Standard / 0.20mm
Infill:
PLA / 2 Shells / 25% or more infill (to ensure a strong bite)
Notes:
Easy prints.... use high infill to increase the strength of the bite. Do not scale down otherwise the mouth may fuse shut and not move.
Bugz are easy...
Remove the Raft if used then your Bugz should be ready to bite and clip onto all sorts of things...
