A full size 3d printable Ghostbusters trouser hose manifold and belt clip for use with 1/2" flexible hose. Up to 4 x 10mm neodymium magnets are seated in the bottom of the magnet and attach to a steel disc on the inside of the uniform. This allows the manifold to simply fall off if the hose gets tangled in something and a none physical attachment makes washing the uniform much easier.
Also a clip to allow the rear end of the hose to attach to the belt.
You will need to place the manifold on a thin sheet of steel and draw around it, then cut out using a saw. Make sure you clean up all the jaggies with a file to make sure there are no injuries!
