Voronoi Elephant Piggy Bank based off of Elephant Ornament on Thingiverse. I was just experimenting with creating Voronoi type files and it turned out so well I decided to share.
Depending on the filament used and shrinkage you may have to adjust the size when you print the plug. I also designed the Plug tabs a little big so you can file an exact fit.
I provided Screen shot of settings I used to print... Hope it helps... Happy Printing
Printer:
Gary 1 (Custom Built 200x300mm)
Rafts:
No
Supports:
No
Resolution:
.4mm Nozzle - .3mm layers
Infill:
25%
Notes:
I printed in PETG without a fan as i do not have one setup yet. If it is printing too hot the tip of the trunk gets a little soft but still turns out OK.. with a fan I would bet it will be perfect.
