Continuing with my appreciation of things on my desk, I bring you Thor's Hammer. There are other tiny thor hammers on thingiverse, but none of the small ones had the nice run work. So I modeled this one up, along with a base that is supposed to look like its being broken by the hammer.
Be sure to print two of the end caps
Printer:
Hatchbox Alpha
Rafts:
No
Supports:
No
Resolution:
150 Microns
Infill:
20%
Notes:
I printed this whole thing without supports. The main body of the hammer had bad overhangs around the opening for the handle, but after 10 layers it had built up enough that it finished off just fine, and since all the ugly is sealed off on the inside, I didn't care.
The end caps and the top cap, have to be glued on, but the handle is held just fine by friction
This was modeled in Fusion 360