Legends tell of a mighty Viking-themed lid designed for a whisky glass. Behold, the Helm of Glencairn! Originally designed by 4MULE8.
In trying to print this I experienced a few problems:
Plenty of them related to the needed 'bridging' mentioned in 4MULE8's print notes.
I has difficulty snapping off the supports on the sides when using some filaments.
It did not fit the smaller Glencairn glasses.
(Add to this that my printer was going through a fase of printing round things oval).
My solution was to adapt the interior of the Helm and 'cut' a few bits off the horn-supports.
Nine attempts later: I am now happy to present you with the DUO-size Helm of Glencairn!
The same helm will fit the small size and the normal size (and the slightly thicker glasses from Highland Park Appreciation Society).
Printer:
Sculpto
Rafts:
Yes
Supports:
No
Resolution:
Fine (0,15 mm)
Notes:
PLA
Copied from 4MULE8's notes
Designed to print without additional supports. There are two supports already included in the STL file, which snap off cleanly after printing.
