This is more a make than a remix - I only post it as a remix because I had to fix two parts of the handle (they were non-manifold, Slic3r didn't like them at all). All other parts are unchanged and are included here for completeness.
Printer:
Prusa i3
Rafts:
No
Supports:
Yes
Resolution:
0.2 mm
Infill:
3 to 20%
Notes:
The head ("body") was printed with 3% (yes, three percent) rectilinear infill, while the handle was printed with 20% infill, honeycomb pattern. Both were printed with 5 top/bottom solid layers and three perimeters. Atomic "Metallic Silver" PLA, 210°C, 60 mm/sec max speed.
Total print time, about 50 hours, and around 220 meters of filament.
I used the "solid" head half.
The model shown here is printed at full-size, and is displayed on the printer that made it.
Other than removing the supports, adding color to the handle (expertly applied with a brown Sharpie :-) ), and some minor scraping and sanding to make everything fit perfectly, no post-processing was done.