Cactuar from Final Fantasy on a display stand. I made the model too big in solid works, scale both the Cactuar and Stand by the same values to make them fit.
The hole in the stand is intentionally smaller than the foot peg. This is so you can drill the hole in the stand to the appropriate dimension for a good fit.
Printer:
DaVinci 1.0 - Flashed Repetier
Rafts:
No
Supports:
No
Resolution:
.3mm
Infill:
20% - Rectilinear
Notes:
Model is in 2 halves so no supports are needed, just super glue the two pieces together and sand the foot peg a little to make it fit the stand. Use "puffy paint" to color in the eyes and mouth. (the t-shirt drawing stuff they sell at wal-mart).
Used solid works to model the Cactuar and Stand then saved them as an .stl file.
