Summary

This is a side-release buckle or parachute buckle that works with 3/4 inch straps or 'webbing'.

I modeled this so I could print a replacement for a broken clip on my pack. Originally printed in PLA, which has been surprisingly functional so far, but I've reprinted in PET+ which has a much better flexible quality to it and should last far longer.

Prints best with support everywhere, especially for the female side of the buckle.

Print Settings

Rafts: Doesn't Matter

Supports: Yes

Resolution: 50-150 micron

Infill: 40%

Notes:

Is most functional when printed in PET+ or similar, but also works in ABS, PLA, etc.