A proxy model for Epic scale Warlord Titan (40k or armageddon etc).
super glue for assembly.
Some of the parts are right or left specific, some are ambidextrous.
if the stl has X2 in the name then print two, one for left and one for right (most leg bits, shoulder guns, arm mounts).
some parts require rotation to print with best facing upward (my program allows rotation so that's what i do).
tolerances - bring sandpaper or a small file to get some of the bits to fit.
have included a 'full model' stl just for thingiview.
the model is based in part on this model http://www.semaker.com/productdetail/7210 though i couldn't get the 75Mb stl to actually open in sketchup. the pics were useful though. based more on this model than the original Epic version but i also checked out the originals for some inspiration as well.
can look fairly 'upright' without any posing but you can position the legs to lower the stance and make it more "bam ! action!".
the model is low-poly in places but when it prints it smooths to an acceptable level at this scale. as usual paint will add a lot to the final product but there should be enough step-planes in the model to make the silhouette interesting.
i did contemplate modelling the newer 'mars pattern' version but frankly i like my titans how is like my dreadnoughts and fliers, boxy-as.
there are a couple of pre-paint pics, the body parts had a small but acceptable amount of lift which i bogged with liquid green stuff.
