Found no gas mask filters for 3D printing anywhere so I made my own.
Needed a prop filter for a short movie and I didn't want to waste the real filter I own.
Printer:
CoLiDo DIY
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0,3 mm
Infill:
0%
You can tell that the print itself didn't turn out too good on my side. My printer is quite cheap, and during the printing of the two parts I had to buy a new filament (gray), which appears to be worse in quality.
During printing, the sides cracked/separated, and I used tape to keep it from breaking any further.
Later on I glued on everything that looked structurally weak. Looks ugly, but I intend to paint the whole thing later anyways.
Made in Autodesk Inventor using coolOrange threadModeler for the top screw (https://apps.autodesk.com/INVNTOR/en/Detail/Index?id=2540506896683021779)
