by servone001, published
Printer Brand: Stratasys
Printer: uPrint SE
Rafts: Yes
Supports: Yes
Resolution: Medium to High
Notes:
The tolerances on this are not great. I'm no engineer... just a beginner. Legos will stick to it, but may be loose in some places. Your best bet is to attach a flat lego piece (2X4 works well) first, then connect additional pieces to that. Good luck! *** Gang... It was indeed saved/uploaded in inches. If it makes your set up any easier, the final specs are: 3.0 X 4.79 INCHES. I think on some occasions I had to re-size it the slicing software before printing. Sorry about the confusion.
