So all in all this was a quick and easy model i made after the skyward sword logo with some insperation from the triforce logo of wind waker.
Recommend to use 1.2mm stand width on really upscaled or downscaled prints. As the big models you might have a weight issue with 0.8 mm supports between the parts not being able to hold up.The small prints may have problem printing 0.8 down scaled. But else the 0.8mm looks better. I added files without support between the parts incase you want to glue it to something and a model with no base incase you want to hang it on the wall.
Send me a message on thingiverse if you got any constructiv critism i appriciate it.
Sorry for bad grammar. I am norwegian and not to skilled with english yet.
Printer:
Cr-10
Rafts:
No
Supports:
No
Resolution:
0.05
Infill:
5
Notes:
I took 0.05mm resolution just to see how it turns out probably fine using 0.2 or less. i had 5 top layers because its 0.05 res. if you are going with higher res 2-3 layers should do it.
I desinged this in fusion 360 and made a short local render of the model.
