Remixed rubber band gun to reduce the number of parts printed. I was able to print all pieces in 3 batches rather than 4.
Printer Brand:
PrintrBot
Printer:
Play
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Infill:
20
Notes:
Supports need for "combined bottom" to support the trigger guard. All other pieces print support free.
I cut a rubber band in half and tied the ends together to put around the trigger to give it the spring back.
Gun is held together by pins, no glue required. I did have to trim the corners of the pins slightly in order to get it to fit. A good squeeze or heal palm on the table got them to fit together.
