I needed more utensil hooks near the kitchen sink. The only room I had to mount them was on the side of the nearby cabinets. So I made these sideways hooks.
When I was done, I thought why not put an extra peg on each of the back hooks. So I modified my design making the pegs longer and slimmer at the same time. I also changed their position.
The mounting holes are awkwardly placed so your screwdriver will be at a slight angle, but pilot holes helped.
Printer:
Kodama Trinus
Rafts:
No
Supports:
No
Notes:
I printed these flat. I was afraid to use supports, and at the same time afraid not to.
But as it turned out, the sloppy underside of the horizontal bar was easy to clean up with a pocket knife.
