by SumboDesign, published
Iron Man statue/figure with and without printing support columns. Enjoy!
Important: I have updated the model (29/06/15) so if you have downloaded the previous version discard it as it may lead to errors. V2 fixed so less errors with slicer.
My print info for Iron Man Statue Fixed (Pic of model above)
Print time: Just over 4 hours
Print Settings: Med Res/Med Speed
Printer: Mamba 3D
Object scale: X Scaled to 1.3
Object height: 10.5cm inc. base
Printed with: PLA_1.75
Total Layers: 683
Total lines: 172035
Filament Needed: 6484mm
Errors: Slight error on right hand (Fingers only)
Disclaimer: This is fan art, I do not claim to own the rights of Iron Man (Trademark Marvel). CC, attribution & non-commercial apply.
