T-800 endoskeleton model
Printer Brand:
Wanhao
Printer:
Duplicator 6
Rafts:
Yes
Supports:
Yes
Resolution:
0.15 - 0.2
Infill:
15%
Notes:
This model should be printed by parts. And there are meny.
The parts are different sizes and forms so you need to use settings accordingly.
Big ones 0.15 layer
And small ones like tubes wires and fingers 0.2
Painting
Each part must be painted and attached individually. To avoid detail loss.
Painting
1 coat of filler, sandbrushing
2 coats of glossy paint
1 coat of chrome paint
Extra optional: There is some electronics and wiring in my final model. So there are slots and places for that.
Electronics
Just go to the local store and buy 2 cheap solar lamps for the garden. Solar battery should be in size of 3cm. disassembe them. If you are familliar with this you will understand the rest by your self.
Eye diode is wired trough the right leg.