This is fully articulated female figure for artists. It made it in Zbrush using my old sculpt. There are few additional hand gestures included. And it can stand on her legs! (Didn't expect that)
Despite i test printed it a lot still could not make joints to fit perfectly. You may use small pieces of masking tape to fix this.
Printer:
CR-10
Rafts:
Yes
Supports:
Yes
Resolution:
.15 or less recommended
Infill:
15
Notes:
Wall thikness - 1mm
Joints
Joints may not fit well from print to print. I used masking tape to make it fit better.
