This is a printable model of the Combine turret from Half Life 2.
I used the original model as a reference, but this model was made from scratch in Blender.
Designed with ease-of-printing in mind, there is one flat surface on every part, so that you don't have to use shitloads of support or a raft. The parts are already rotated to the best printing position.
Instructions:
Print with support enabled
Make sure everything fits together
Add Superglue to the holes and put it together
Shoot at Freeman
Fall over and panic!
The gun can swivel up and down if you don't glue it, the body and legs are meant to be glued.
The 4 holes on the gun are there to insert some small pieces of wire to match the look of the original, as there were wires coming out the back in a loop.
The combine turret design, that i used as a reference for this, as well as the HL2 logo i used in the preview image belong to Valve.
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25%
Notes:
You can either lay the four parts out yourself or use the pre-laid-out stl, it was made to fit on a 20x20cm (8x8inch) buildplate.
