I had been looking for a YT-2400 to print out and use as terrain for my roleplaying group, and was just not satisfied with what I found, so I took the dimensions from YT-2400 (Outrider) by the24hrpartyzone and remodeled it based on my own whims. Fortunately with all the different depictions of star wars ships you can pretty much choose what features you like and mash them together into one ship! And wow, hull panels are a pain to draw!
Multiple parts:
p03 x2
p05 x4
p06 x2
p07 x5
p08 x3 (back and side landing gear bays)
p08f x2 (front landing gear bay, will need a bit of sanding on the front to fit)
Notes:
Most pieces can be printed without supports, and I have modeled in supports on the command pod and guns, that should work when the part is oriented properly. The only part that gave me problems was the large overhang in the engine, but it wasn't bad enough to make me print anything again.
Full pieces for the 3 separate hull parts as well as split parts that just barely fit the bed of my printer when scaled to 150%, there's no need to print both.
Landing gear struts and hull pins are modeled at 2mm, but I used 3mm when assembling my 150% scaled ship.
I'll include a drawing of the landing gear struts when I'm finished assembling it.
